
power button to turn on the Yakumo delta 300 GPS. You can then start to
align the touch screen.
7.6 Connection Problems
Cable Connection Problems
Make sure that you have installed the correct version of ActiveSync on your
desktop computer. Install the version ActiveSync included with your
Yakumo delta 300 GPS.
Make sure that your Yakumo delta 300 GPS and your desktop computer are
both turned on before establishing the connection.
Make sure that the cable is securely plugged into the USB port on your
desktop computer. Connect the USB cable directly to your desktop
computer—do not run the cable through a USB hub.
Make sure that the USB connection is enabled in ActiveSync on your
desktop computer. If the USB connection is already enabled, disable the
USB connection, close the Connection Settings window and then reopen
and re-enable the USB connection.
Reset your Yakumo delta 300 GPS before connecting the cable. (See
section 7.1.) Always disconnect your Yakumo delta 300 GPS before you
restart your desktop computer.
Connect only one Yakumo delta 300 GPS or personal digital assistant to
your desktop computer at a time.
Make sure that you do not have any other active connections. Tap
and
tap
Today
. Tap or at the bottom of the screen and then tap
Disconnect
.
Infrared Connection Problems
Transfer only one file, or no more than 25 contact cards, at a time.
Position the IR ports so that they line up in a distance less than 20 cm (8
inches) but more than 5 cm (2 inches) apart.
Make sure that there are no obstacles between the two IR ports.
98
Comentarios a estos manuales