
7.2 Restoring Factory Default State
In some cases, you may need to restore your Yakumo delta 300 GPS to the
factory default state by clearing the memory (RAM) from your Yakumo delta
300 GPS. For example, you should clear the memory:
When your Yakumo delta 300 GPS does not respond after being reset.
When you forget your password.
Clearing the memory means all data you have entered in RAM, including all
files, system settings and additional programs you have installed, will be erased.
(Programs installed to ROM at the factory are not affected.)
CAUTION:
To ensure the integrity of your data should it be necessary to clear the memory, you’re
advised to regularly back up your data. (For more information on backing up data, see
section 3.5.)
Do not slide the battery switch unless it is necessary.
Follow this procedure to clear the memory from your Yakumo delta 300 GPS:
1. Backup your information if necessary.
2. Disconnect all cables, including the AC adapter, from your Yakumo delta
300 GPS.
3. Stop all running programs by tapping
Settings
System
tab
Memory
icon
Running
Programs
tab
Stop All
.
4. Use the stylus to slide the battery switch to the
OFF (up) position.
5. Wait for 1 minute and then slide the switch back to
the ON (down) position.
6. Your Yakumo delta 300 GPS will automatically
turn on and prompt you to start the setup wizard.
7. Follow the onscreen instructions to complete the
setup wizard.
Wait for 1 minute.
94
Comentarios a estos manuales